D-Link xStack DGS-3620-52P, Руководство пользователя

Страница: 791 / 1170

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
786
Restrictions
None. (EI Mode Only Command)
Example
To display OSPFv3 virtual neighbor:
DGS-3620-28SC:admin# show ospfv3 virtual_neighbor
Command: show ospfv3 virtual_neighbor
Transit Router ID Of Virtual Neighbor
Area ID Virtual Neighbor State
--------------- ---------------- ----------------
1.1.1.1 30.30.30.30 Full
Total Entries: 1
DGS-3620-28SC:admin# show ospfv3 virtual_neighbor 6.6.6.6 20.20.20.20
Command: show ospfv3 virtual_neighbor 6.6.6.6 20.20.20.20
Transit Area ID: 6.6.6.6
Virtual Neighbor ID: 20.20.20.20
Virtual Neighbor Options: 19
Virtual Neighbor State: Full State Changes: 9 times
Total Entries: 1
DGS-3620-28SC:admin#
70-16 config ospfv3
Description
This command is used to configure an OSPFv3 interface.
Format
config ospfv3 [ipif <ipif_name 12> | all] {area <area_id> | priority <value 0-255> |
hello_interval <sec 1-65535> | dead_interval <sec 1-65535> | instance <value 0-255> | metric
<value 1-65535>| state [enable | disable] | passive [enable | disable]} (1)
Parameters
ipif - Specifies the OSPFv3 IP interface name used.
<ipif_name 12> - Enter the OSPFv3 IP interface name used here. This name can be up to 12
characters long.
all - Specifies that all the OSPFv3 IP interfaces will be used.
area - (Optional) Specifies a 32-bit number in the form of an IPv4 address that uniquely identifies
the OSPFv3 area in the OSPFv3 domain.
<area_id> - Enter the area ID used here.
priority - (Optional) Specifies the priority used in the election of the Designated Router (DR).
<value 0-255> - Enter the priority value used here. This value must be between 0 and 255.
The default value is 1.