D-Link xStack DGS-3612G series, Инструкция по эксплуатации

Страница: 224 / 326

xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
33
R
OUTING
T
ABLE
C
OMMANDS
The routing table commands in the Command Line Interface (CLI) are listed (with the appropriate parameters) in the following table.
Parameters Command
create iproute <network_address> <ipaddr> {<metric 1-65535>} {[primary | backup]}
create iproute default <ipaddr> {<metric 1-65535>}
delete iproute default
delete iproute <network_address> <ipaddr> {[primary | backup]}
show iproute {<network_address>} {[static | rip | ospf]}
create iproute ipv6 <ipv6networkaddr> <ipv6addr> {<metric 1-65535>}
delete iproute ipv6 {<ipv6networkaddr> <ipv6addr> | all}
show iproute ipv6 {<ipv6networkaddr>}
create iproute ipv6 default <ipv6addr> {<metric 1-65535>}
delete iproute ipv6 default
Each command is listed, in detail, in the following sections.
create iproute
Purpose Used to create IP route entries to the Switch’s IP routing table.
Syntax create iproute <network_address> <ipaddr> {<metric 1-65535>}
{[primary | backup]}
Description This command is used to create a primary and backup IP route entry to
the Switch’s IP routing table.
Parameters
<network_address>
−
IP address and netmask of the IP interface that is
the destination of the route. The address and mask information can be
specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or
in CIDR format, 10.1.2.3/8).
<ipaddr>
−
The gateway IP address for the next hop router.
<metric 1-65535>
−
Allows the entry of a routing protocol metric entry,
representing the number of routers between the Switch and the IP
address above. The default setting is 1.
[primary | backup] - The user may choose between Primary and
Backup. If the Primary Static/Default Route fails, the Backup Route will
support the entry. Please take note that the Primary and Backup entries
cannot have the same Gateway.
Restrictions Only administrator-level users can issue this command.
Example usage:
Command: create iproute 10.48.74.121/8 10.1.1.254 1
To add a single static address 10.48.74.121, mask 255.0.0.0 and gateway 10.1.1.254 to the routing table:
DGS-3612G:4#create iproute 10.48.74.121/255.0.0.0 10.1.1.254 1
Success.
DGS-3612G:4#
221