xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Example usage:
To create a VRRP entry:
DGS-3612G:4#create vrrp vrid 1 ipif Darren ipaddress 11.1.1.1 state
enable priority 200 advertisement_interval 1 preempt true critical_ip
10.53.13.224 critical_ip_state enable
Command: create vrrp vrid 1 ipif Darren ipaddress 11.1.1.1 state enable
priority 200 advertisement_interval 1 preempt true critical_ip 10.53.13.224
critical_ip_state enable
Success.
DGS-3612G:4#
config vrrp vrid
Purpose
To configure a VRRP router set on the Switch.
Syntax
config vrrp vrid <vrid 1-255> ipif <ipif_name 12> {state [enable |
disable] | priority <int 1-254> | ipaddress <ipaddr> |
advertisement_interval <int 1-255> | preempt [true | false] |
critical_ip <ipaddr> | critical_ip_state [enable | disable]}
This command is used to configure a previously created VRRP
interface on the Switch.
vrid <vrid 1-255>
- Enter a value between 1 and 255 that uniquely
identifies the VRRP group to configure. All routers participating in
this group must be assigned the same
vrid
value. This value MUST
be different from other VRRP groups set on the Switch.
ipif <ipif_name 12>
- Enter the name of a previously configured IP
interface to configure a VRRP entry for. This IP interface must be
assigned to a VLAN on the Switch.
state [enable | disable]
– Used to enable and disable the VRRP
router on the Switch.
priority <int 1-254>
- Enter a value between 1 and 254 to indicate the
router priority. The VRRP Priority value may determine if a higher
priority VRRP router overrides a lower priority VRRP router. A higher
priority will increase the probability that this router will become the
Master router of the group. A lower priority will increase the
probability that this router will become the backup router. VRRP
routers that are assigned the same priority value will elect the
highest physical IP address as the Master router. The default value
is 100. (The value of 255 is reserved for the router that owns the IP
address associated with the virtual router and is therefore set
automatically.)
ipaddress <ipaddr>
- Enter the virtual IP address that will be
assigned to the VRRP entry. This IP address is also the default
gateway that will be statically assigned to end hosts and must be set
for all routers that participate in this group.
advertisement_interval <int 1-255>
- Enter a time interval value, in
seconds, for sending VRRP message packets. This value must be
consistent with all routers participating within the same VRRP group.
The default is 1 second.
preempt [true | false]
– This entry will determine the behavior of
backup routers within the VRRP group by controlling whether a
higher priority backup router will preempt a lower priority Master
router. A true entry, along with having the backup router’s priority set
higher than the masters priority, will set the backup router as the
Master router. A false entry will disable the backup router from
becoming the Master router. This setting must be consistent with all
Description
Parameters
217
