xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
27
T
IME AND
SNTP
C
OMMANDS
The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NTP)) commands in the Command Line
Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
config sntp
{primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
show sntp
enable sntp
disable sntp
config time
<date ddmthyyyy> <time hh:mm:ss>
config time_zone
{operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
config dst
[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-
sat>| s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_week
<end_week 1-4,last> | e-day <end_day sun-sat> | e_mth <end_mth 1-12> |
e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]} | annual {s_date
<start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time hh:mm> |
e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time <end_time
hh:mm> | offset [30 | 60 | 90 | 120]}]
show time
Each command is listed, in detail, in the following sections.
config sntp
Purpose
Used to setup SNTP service.
Syntax
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval
<int 30-99999>}
Description
Use this command to configure SNTP service from an SNTP server.
SNTP must be enabled for this command to function (See
enable
sntp
).
Parameters
primary
−
This is the primary server the SNTP information will be taken
from.
secondary
−
This is the secondary server the SNTP information will be
taken from in the event the primary server is unavailable.
poll-interval <int 30-99999>
−
This is the interval between requests for
updated SNTP information. The polling interval ranges from 30 to
99,999 seconds.
Restrictions
Only administrator-level users can issue this command. SNTP service
must be enabled for this command to function (
enable sntp
).
<ipaddr>
−
The IP address of the primary server.
•
•
<ipaddr>
−
The IP address for the secondary server.
Example usage:
To configure SNTP settings:
DGS-3612G:4#config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DGS-3612G:4#
195
