D-Link DXS-3250E - xStack Switch, Руководство по установке в сети

Страница: 37 / 424

DXS-3227, DXS-3227P, DXS-3250 and DXS-3250E EWS User Guide
Page 36
Configuration Overview
Before assigning a static IP address to the device, obtain the following information from the network administrator:
• A specific IP address allocated by the network administrator for the switch to be configured
• Network mask for the network
There are two types of configuration: Initial configuration consists of configuration functions with basic security
considerations, whereas advanced configuration includes dynamic IP configuration and more advanced security
considerations.
After making any configuration changes, the new configuration must be saved before rebooting. To save the
configuration, enter the following CLI command:
Initial Configuration
Initial configuration, which starts after the device has booted successfully, includes static IP address and subnet mask
configuration, and setting user name and privilege level to allow remote management. If the device is to be managed
from an SNMP-based management station, SNMP community strings must also be configured. The following
configurations are completed:
• Static IP Address and Subnet Mask
• Static Route Configuration
• User Name
• SNMP Community strings
Static IP Address and Subnet Mask
IP interfaces can be configured on each port of the device. After entering the configuration command, it is recommended
to check if a port was configured with the IP address by entering the “show ip interface” command.
The commands to configure the device are port specific.
To manage the switch from a remote network, a static route must be configured, which is an IP address to where packets
are sent when no entries are found in the device tables. The configured IP address must belong to the same subnet as
one of the device IP interfaces. To use the
ip route command, the device mode must be changed from switch to router .
To configure a static route, enter the command at the system prompt as shown in the following configuration example
where 101.101.101.101 is the specific management station, and 5.1.1.100 is the static route:
Console# copy running-config startup-config
Console#
configure
Console(config)#
interface vlan
1
Console(config-if)#
ip address
100.1.1.1 255.255.255.0
Console(config-if)#
exit
Console#
ip route
192.168.2.0/24 100.1.1.33