Document Number: 002-10689 Rev *H
Page 61 of 166
S6J32E, S6J32F, S6J32G Series
*1: These parameters are based on the condition that VSS = AVSS = DVSS = 0.0 V.
*2: Take care that DVCC and AVCC5 do not exceed VCC5 at, for example, the power-on time.
It is strongly recommended to set VCC5, DVCC, and AVCC5 to the same voltage during operation (see *13).
*3: The maximum output current is defined as the value of the peak current flowing through any
one of the corresponding pins.
*4: The average output current is defined as the value of the average current flowing through any
one of the corresponding pins for a 10 ms period. The average value is the operation current ×
the operation ratio.
*5: The total output current is defined as the maximum current value flowing through all of
corresponding pins.
*6: Output of 5-V pins.
*7: Output of SMC pins.
*8: Output of 5-V/3-V pins.
*9: Output of 3-V pins.
*10: Output of I
2
C.
*11: Output of Media LB pins
*12: VI or VO should never exceed the specified ratings. However, if the maximum current to/from
an input is limited by a suitable external resistor, the ICLAMP rating supersedes the VI rating.
*13: Take care that the output voltage of ADC shared pins does not exceed AVCC5+0.3 V because ADC Analog input pins
(AN0-49) are internally connected to the analog elements. It is strongly recommended to set VCC5, DVCC, and AVCC5 to
the same voltage.
*A: Relevant pins: All general-purpose ports and analog input pins
• Corresponding pins: all general-purpose ports
• Use within the operation assurance condition (See 8.2. Operation Assurance ).
• Use at DC voltage (current).
• The +B signal should always be applied by connecting a limiting resistor between the +B signal and the microcontroller.
• The value of the limiting resistor should be set so that the current input to the microcontroller pin does not exceed rated values
at any time regardless of instantaneously or constantly when the +B signal is input.
• Note that when the microcontroller drive current is low, such as in the low power consumption modes, the + B input potential
can increase the potential at the VCC pin via a protective diode, possibly affecting other devices.
• Note that if the +B signal is input when the microcontroller is off (not fixed at 0 V), since the power is supplied through the pin,
the microcontroller may operate incompletely.
• Note that if the +B signal is input at power-on, since the power is supplied through the pin, the power-on reset may not function
in the power supply voltage.
• Do not leave +B input pins open.
• It is recommended to confirm that the maximum ratings at the pins is not exceeded using simulation based on the IBIS model.
Variation of the resistance and voltages shall be included for this simulation.
Содержание Traveo S6J32E Series
Страница 102: ...Document Number 002 10689 Rev H Page 102 of 166 S6J32E S6J32F S6J32G Series ...
Страница 105: ...Document Number 002 10689 Rev H Page 105 of 166 S6J32E S6J32F S6J32G Series ...
Страница 129: ...Document Number 002 10689 Rev H Page 129 of 166 S6J32E S6J32F S6J32G Series ...
Страница 140: ...Document Number 002 10689 Rev H Page 140 of 166 S6J32E S6J32F S6J32G Series tABEZ ZIN tZABE AIN BIN ...
