CynkoMet RS-1500, Инструкция по использованию и эксплуатации

Страница: 30 / 101

Cynko Met
RS-1500
30
•
Check all lubrication points of the spreader, if necessary, lubricate the machine
(section 6.10).
•
Check for proper tightening of nuts fixing the driving wheels (Tab. 7, section 6).
•
Make sure that the hydraulic and electrical connections in the agricultural tractor are
compliant with the machine’s connection points, otherwise do not connect the
spreader.
• Adjust the height of the shaft location in the spreader or the position of the upper
transport hitch on the tractor through a regulated bracket.
Trial drive / start
If all the above steps have been performed and the technical condition of the
spreader does not raise any objections, connect the machine to the tractor in
compliance with the following sequence.
•
secure the spreader against uncontrolled rolling by placing wheel chocks under the
wheel.
•
set the spreader drawbar at the height of the hitch in the tractor using the adjustable
support.
•
perform the reversing maneuver and couple the drawbar to the tractor's hitch.
•
switch off the tractor’s engine (turn the key to the desired position and remove the
key from the ignition), set the parking brake on the tractor.
•
check the correctness of the connection of the drawbar to the hitch in accordance
with the instruction manual of the tractor.
•
connect the power take-off and fasten shaft guards into place. The shaft must have
guards in good condition.
•
Connect all installations according to the instructions of the tractor and spreader.
•
raise the adjustable bracket and set the wheel of the bracket in the “up” position (so
that it does not catch on the ground during driving) (fig.10).