CynkoMet RS-1500, Инструкция по использованию и эксплуатации

Страница: 43 / 101

Cynko Met
RS-1500
43
•
check the functioning of the electrical system,
•
checking and performance of lubrication, according to the instructions (section 6.10),
•
checking the tire pressure (tab. 3),
•
checking all locks/latches (e.g. side walls), whether they are properly closed and
secured by pins, and that there is no risk of spontaneous opening.
All detected faults are to be removed as soon as they are detected. Use of a
faulty spreader may have serious consequences.
NOTE!
NOTE!
If you need to lift the wheels of the spreader, observe the
following rules:
- the spreader attached to the tractor is to be set in the direction for
driving straight ahead on a flat, stable base, and then tractor’s parking
brake is to be engaged,
- plant securing chocks under the wheel of the spreader that will not
be raised,
- place the jack under the load-carrying beam at the point marked by
a special informational sticker (tab. 2 item 12, Fig. 7) and raise it,
- secure the spreader against falling down in the event of a jack
failure by placing a stable support under the machine.
NOTE!
NOTE!
In the case of noting any irregularities in the operation or
damage to systems or assemblies of the spreader, the
machine must be taken out of use until repair and removal of
defects.
It is forbidden to carry out service and repair work under
a burdened cargo bed and with the tractor engine running. All
maintenance work performed after disconnecting the PTO.
All maintenance and repair tasks are to be performed in
compliance with general occupational health and safety rules.
In the case of injury, the wound should immediately be washed
and disinfected. In the case of serious injuries, consult a
physician.