CynkoMet RS-1500, Инструкция по использованию и эксплуатации

Страница: 62 / 101

Cynko Met
RS-1500
62
unscrewed and taken off wheels or on wheels secured with chocks, but with
disassembled and folded upper extensions.
Loading and unloading of a spreader from a car should be carried out using
the loading ramp with an agricultural tractor or using a crane, lever. During operation,
observe the general safety rules with handling operations. Persons operating the
reloading equipment must have the required permissions to use these devices.
When loading / unloading using the tractor, the spreader must be properly
connected with the tractor according to the requirements contained in this manual.
The tractor's brake system must absolutely be serviceable and checked prior to exit
from or entry onto a ramp.
When loading / unloading using a crane or a lever, the spreader is to be lifted
with the help of approved fasteners designed to carry the load with sufficient capacity.
The belts must be in good condition, they cannot show any signs of damage.
The belts should be placed under the lower frame of the spreader in such
places that when lifting the machine the belts do not have the possibility of moving,
and the spreader when moving is not tilting. If there is a possibility of damage or
fraying of belts against components of the machine, put washers in these areas.
In order to avoid compression of the walls to the inside the spreader, when
loading with the use of a crane, use a special traverse, where the places of hooking
the belts will be spaced wider than the total width of the machine.
The spreader should be attached firmly to the platform of the transport mean
with belts, chains, lashing or other fastening means equipped with a tightening
mechanism. Fastening elements are to be fastened to fixed structural elements of the
spreader (longitudinal beams, cross-bars, etc.). Transport handles are welded to the
longitudinal bar of the bottom frame, one pair on each side of the spreader (fig. 23).
Use certified and technically efficient fastening means. Frayed belts, cracked mounting
brackets, opened or corroded hooks or other damage may disqualify the given mean
for use.