CYBEX Arc Trainer 600A, Руководство по эксплуатации для владельца

Страница: 83 / 107

Cybex Arc Trainer Owner’s & Service Manual
Page 7-27
Table of Contents . . . . . . . . . iii
7 Service
Warnings/Cautions . . . . . . . 7-1
Test Mode . . . . . . . . . . . . . . 7-2
LED Functions . . . . . . . . . . . 7-3
Key Functions . . . . . . . . . . . 7-3
Error Codes . . . . . . . . . . . . . 7-4
Speed Sensor Adjustment . 7-5
Drive Belts . . . . . . . . . . . . . . 7-7
Eddy Current Brake. . . . . . 7-13
Elevation Motor . . . . . . . . . 7-16
Power Switch . . . . . . . . . . 7-20
Upper Pillow Blocks . . . . . . 7-22
Lower Pillow Blocks . . . . . 7-26
Pedal Arm & Linkage Arm . 7-28
Lower Control Board . . . . . 7-29
Upper Display Board . . . . . 7-31
Contact Heart Rate Board. 7-33
CSAFE Board . . . . . . . . . . 7-35
Upper Display Cable . . . . . 7-36
Lower Display Cable . . . . . 7-38
Display Overlays . . . . . . . . 7-41
Parts List . . . . . . . . . . . . . . 7-43
Exploded Views. . . . . . . . . 7-45
Schematic . . . . . . . . . . . . . 7-51
3. Detach the connecting rods.
A. Using a 3/16” hex key, remove the screw securing each connecting rod
to each crank. See Figure 4.
B. Place a cloth on the frame where each connecting rod will rest.
C. Rest each rod on a cloth to prevent scratches. See Figure 4.
4. Remove the side covers.
A. Using a Phillips head screwdriver, remove the six screws and six
washers securing each side cover in place. See Figure 5.
B. Remove both side covers. NOTE: The gasket will come off with one of
the side covers. See Figure 5.
5. Remove the lower pillow blocks.
A. Place a wooden block under the inner frame. See Figure 22.
B. Using a 9/16” socket wrench
and a 9/16” open end wrench,
remove the two bolts, four flat
washers and two nuts from
each of the bottom pillow
blocks. See Figure 22.
C. Pull each pillow block and pin
off the frame. See Figure 22.
NOTE: You may need to tilt the
pillow block up or pry it up off
the frame. There is a pin in
each pillow block.
D. Discard the pillow blocks and
pins (if applicable).
6. Attach the new lower pillow
blocks.
A. Confirm that a pin protrudes
out of the back of each pillow
block about 1/4” and flush with
the front.
B. Slide each pillow block on the shaft and each pin in its slot on the
frame.
NOTE: Orientation of pillow block sleeve and set screws must go
toward the inside. When installed properly the pins should be flush with
the front of the pillow blocks. You may need to tap them in.
C. Using a 1/8” hex key, tighten the two set screws on each pillow block.
D. Remove the wooden block from under the inner frame. See Figure 22.
Figure 22
Pin (2)
Pillow Block (2)
Flat Washer (8)
Bolt (4)
Nut (4)
Loosen Set
Screws
(2 Each Side)
Wooden Block
Under Inner Frame