CYBEX Arc Trainer 600A, Руководство по эксплуатации для владельца

Страница: 64 / 107

B. Place a cloth on the frame where each
connecting rod will rest.
C. Rest each rod on a cloth to prevent
scratches. See Figure 4.
4. Remove the side covers.
A. Remove the six screws and six
washers securing each side cover in
place. See Figure 5.
B. Remove both side covers. NOTE: The
gasket will come off with one of the
side covers. See Figure 5.
5. Remove the crank covers.
A. Using a Phillips head screwdriver,
remove the three screws securing
each crank cover in place. See
Figure 6.
B. Remove both crank covers.
! WARNING: Failure to release the drive
belt tension may cause
personal injury and may
damage the unit.
6. Remove the lower pivot assembly.
A. Using a 7/16” socket wrench, remove
the two screws, two lock washers
and two flat washers from the lower
pivot shaft. See Figure 7.
NOTE: The
tension is now released. The primary
belt can be replaced without
loosening the idler pulley.
NOTE: If you are not replacing the secondary
belt, leave the lower pivot assembly
loose in its place, skip steps 6B-8E
and continue with step 9.
B. Remove the lower pivot assembly out
of the secondary belt and from the
frame. See Figure 8.
7. Remove the secondary belt (if
applicable).
A. Slide the secondary drive belt off the
unit and discard it.
Cybex Arc Trainer Owner’s & Service Manual
Page 7-8
Figure 5
Figure 6
Screw (6)
Side Cover
Crank Cover
Screw (3)
Figure 7
Screw
Lock
Washer
Flat
Washer
Lower Pivot
Shaft
Gasket
Washer (6)