CYBEX Arc Trainer 600A, Руководство по эксплуатации для владельца

Страница: 68 / 107

18. Torque the primary belt (if applicable).
A. Using a 3/8” square-hole torque wrench, pull up until the idler wheel rocks against the
brake and is torqued to 75 ft-lbs.
NOTE: Continue holding the torque wrench at 75 ft-
lbs during the next step.
B. While holding the torque wrench at 75 ft-lbs, use a 1/2” socket wrench to tighten the
top screw on the idler pulley. See Figure 14.
C. Using a 1/2” socket wrench, tighten the bottom screw on the idler pulley. See Figure 14.
19. Attach the crank covers.
A. Place each crank cover in position.
B. Using a Phillips head screwdriver, attach the three screws securing each crank cover
in place. See Figure 6.
20. Attach the side covers.
A. Place each side cover in position in the rubber gasket.
B. Using a Phillips head screwdriver, tighten the six screws and six washers securing
each side cover. See Figure 5.
21. Secure the connecting rods.
A. Using a 3/16” hex key, attach the screw securing each connecting rod to each crank.
See Figure 4.
22. Attach the access cover.
A. While being sure not to pinch any cables, hold the access cover in place. See Figure 2.
Cybex Arc Trainer Owner’s & Service Manual
Page 7-12
This Side
of Bracket
This Side
of Bracket
Top Screw
Bottom Screw
Figure 14
NOTE: Do not
adjust the idler
pulley unless it is
obvious that your
belt is not tensioned
properly.
Idler
Pulley