Cybertech PX922E, Руководство по эксплуатации продукта

Страница: 32 / 42

Misc Commands:
Print Selected Font ESC,ESC 1B,1B
Print Software Revision ESC,1 1B,31
Print Configuration ESC,2 1B,32
Set Printer Defaults ESC,3,ESC 1B,33,1B
Set LineFeed Enable/Disable ESC,K,x 1B,4B,30/31
where x=30=Enable, x=31=Disable
Set Double High On
ESC,d 1B,64
Set Double High Off ESC,e 1B,65
Printing Commands:
Newline CR 0D
Line Feed LF 0A
Set minimum paper length ESC,L,xxxx 1B,4C
Set Print Buffer Length ESC,A,xxx 1B,41
Set Print Density ESC,J,(0-7) 1B,4A,x
Set Print Rate ESC,p,(0-7) 1B,70,x
Print Test Message ESC,I 1B,49
Reprint Stored Message ESC,r 1B,72
Status Commands:
Send status TAB 09
Test Printer ESC,I 1B,49
Send Firmware Version ESC,Q 1B,51
Reprint Commands:
Set new Start code
for reprint ESC,s,x…x,0 1B,73,x…x,00
Set new Stop code
For reprint ESC,t,x…x,0 1B,74,x…x,00
Maintenance mode <ctrl>s 13
Note:
count,num_line & num_bytes is a one byte value with a range of
0 to 255 decimal or 0 to FF Hexadecimal.
x = One ASCII character
l = length, h = height w= width (values are ASCII 0 through 9)
p = 16 bit Hex Pattern
n = number of bits in pattern to use (MSB) justified