Printing Commands
4.2.43 NEW LINE (0D)
This character forces either a print in line mode or sets the X
coordinate to zero and increments the Y coordinate by the current
line size.
4.2.44 LINE FEED (0A)
This causes the paper to advance one line if the line feed
enable is active, if line feed enable is disabled this command is
ignored.
4.2.45 SET MININUM PAPER LENGTH (1B 4C x x x x)
This command sets the minimum length before a cut occurs. The
minimum range is 3"(600 dots @ 200 DPI) or to 20". This is useful
for fixed format data and for fixed coupon or receipt length.
4.2.46 SET PRINT BUFFER LENGTH (1B 41 xxx)
This command sets the absolute buffer length in vertical dots.
The command structure is as follows; 1B 41 33 30 30 will set the
buffer size to 300 vertical lines. If the number of lines used is
larger then the new length, the buffer will be clipped and graphics
or extraneous text may end up in one of the line buffers when
switched to Line Mode or the next line is printed. This mode is
useful for mixing small blocks of text and graphics on a line or
page with a predefined length.
4.2.47 SET PRINT DENSITY (1B 4A 0-7)
The Printer defaults at power on to the print density last set or
the printer default 4. This may be changed via software control.
This gives the programmer wide latitude in setting print quality,
such as change of paper quality, dense graphics at high speed,
light or darker print for a specific line of data. Valid input
values are 0 for the lightest and 7 for the darkest (default = 4).
Содержание PX922E
Страница 1: ...Model PX922E THERMAL PANEL PRINTER PRODUCT MANUAL with ETHERNET Revised February 20 2018...
Страница 10: ...Figure 2 1...
Страница 13: ...FIGURE 2 2...
Страница 14: ...Figure 2 3...
