Cybertech PX922E, Руководство по эксплуатации продукта

Страница: 27 / 42

Reprint Commands
4.2.53 SET NEW START CODE FOR REPRINT (1B 73 x x 00)
This command changes the lead in code for the reprint block.
This defaults to STX(hex 02) for start. The maximum number of
characters (x) is 17.
4.2.54 SET NEW STOP FOR CODE REPRINT (1B 74 X X 00)
This command changes the stop code for the reprint block. This
defaults to ETX(hex 03) for stop. The maximum number of characters
(x) is 17.
4.2.55 SOFTWARE REPRINT (1B,72)
This command will duplicate the reprint manual switch action of
causing a buffer reprint.
4.2.56 REPRINT METHOD
The printer has available a reprint feature. This is available
to the user any time. On the front panel there is a two position
switch. If the switch is actuated towards the ‘FEED’ position the
print feeds paper. If the switch is actuated towards the ‘REPRINT’
position the printer to print a test message. This test print can
be obtained until a block of data containing the START/STOP is
received. Subsequently depressing the Test/Feed switch will cause a
reprint of the stored block of data. The format of the block to be
stored is :
STX x x x x x x x x x x x x x x x x x x x ETX
The STX and ETX codes can be replaced as above. ‘x’ can be any
printable (or control character) up to the input buffer size
(i.e. 28000 characters)