Font & Barcode Commands
4.2.18 SELECT FONT (1B 53 x )
This command will select any one of the printer's resident fonts.
Multiple character sizes may be placed with in a line by using the
positioning commands. Line wrap will occur automatically if the
character width exceeds the maximum horizontal coordinate or the
end of the page when rotation is being used. Font selection values
are 1 through 3.
4.2.19 ROTATE CURRENT FONT (1B 53 52 x )
This command when in page mode will rotate the current font 90,
180, 270 or 0(normal print) degrees and place any succeeding
character in its correct position. When rotating 270 degrees the
buffer will start in the lower left position and set the buffer
length to maximum unless set with the vertical positioning command.
Valid input is R or 1 for normal printing (left to right), D or 2
for 90 degree rotation the Y coordinate will automatically
increment, L or 3 for 180 degrees or upside down printing a newline
will bias the cursor to the right hand side of the page and U or 4
for printing 270 degrees a newline will force the full length of
the buffer with printing going from the bottom up.
4.2.20 SELECT DOUBLE WIDE PRINT ON (1B 53 57)
Double wide character printing is selected.
4.2.21 SELECT DOUBLE WIDE PRINT OFF (1B 53 4E)
Double wide character printing is deselected.
4.2.22 VERTICALLY SCALE FONT (1B 53 56 x )
Fonts may be vertically scaled up 6 times. Valid scale factors are
1 (normal) to 6 (eight times normal height).
4.2.23 HORIZONTALLY SCALE FONT (1B 53 48 x )
Fonts may be horizontally multiplied 6 times. Valid scale factors
are 1 (normal) through 6 (eight times normal width).
4.2.24 SCALE CURRENT FONT (1B 53 4D x )
This command will scale a font in both the horizontal and
vertical directions. Valid values are 1 (normal) through 8.
4.2.25 PROPORTIONAL PRINTING (1B 53 50 x )
The default for the standard fonts is proportional printing on.
Fonts may be forced to mono-spaced which will result in all
characters being equal in width, to the widest character in the
font. Note that some fonts are mono-space only. This command has no
effect if the selected font is a mono-space font. To enable mono-
spacing send an ASCII "0" and to enable proportional spacing send
an ASCII "1".
Содержание PX922E
Страница 1: ...Model PX922E THERMAL PANEL PRINTER PRODUCT MANUAL with ETHERNET Revised February 20 2018...
Страница 10: ...Figure 2 1...
Страница 13: ...FIGURE 2 2...
Страница 14: ...Figure 2 3...
