Cybertech PX922E, Руководство по эксплуатации продукта

Страница: 11 / 42

2.2 CONTROL PANEL
2.2.1 REPRINT/FEED SWITCH
When this switch is actuated in the REPRINT position after the
printer is first powered on a test print will occur. When data is
sent to printer containing the Start/Stop character strings, the
last cycle will print. To clear the reprint buffer, depress the
REPRINT switch and hold for greater than 4 seconds. The LED will
flash indicating the reprint buffer is clear. If REPRINT is
actuated during power up and pins 2 & 3 on the serial port are
shorted, the printer will print the test message until a fault
condition occurs. This is used for factory test.
If the switch is actuated into the FEED position paper will be feed
by the printer; if equipped the take-up will also attempt to take
up paper.
2.2.2 FAULT LED
A flashing LED indicates the printer has a fault condition. The
fault may be out of paper, print head in the open position, or the
printer is over temperature. The actual fault may be found by a
status read of the serial port. In normal operation this LED will
be on.
2.3 PAPER LOADING
1. Open front plastic cover and front of printer to access paper
compartment.
2. Remove old paper core.
3. Insert the new paper into the paper compartment with loose end
of paper exiting front of printer about 6 inches. The front
panel LED should be flashing. Refer to Figure 2.2.
4. Close paper compartment with paper exiting printer. LED should
now be 'ON' steady.
4. Depress the test switch. If there is no image on the paper the
paper is in the printer backwards – reverse it.