CONTROLLED COPY CREATED: 3/21/2014 4:59:41 PM
17
Figure 9: Open and Remove Patch from Packaging
3.
Align the triangle on the plastic Patch connector with the triangle notch on theunderside of the
Sensor (Figure 10).
Figure 10: Align Triangles on Sensor and Patch
Note:
The Sensor and Patch can only be connected when properlyaligned. The triangle
notch on the Sensor and triangle on the Patch must face the same direction.
Caution:
If moisture is present on or near the back of the Sensor or the contacts of the
Patch, do not assemble. Doing so can permanently damage the System. Dry the parts using a
soft cloth, paper towel, or cotton swab before proceeding.
4.
Apply firm pressure to the top and bottom of the Sensor to snap the Patch and Sensor
together(Figure 11). Ensure all four corners of Sensor snap into place.
