Currier Tech Ezip, Руководство пользователя, Страница: 34 / 123

34
press to turn on the bicycle
After pressing ‘Power’, all eight meter lights will flash in
sequence, indicating that the bike is ready to ride.
If your bike has an additional physical switch or battery
selector located behind or in front of the batteries, be sure
it is turned to the proper position before pressing ‘Power’.
the lights indicate
remaining charge
The battery gauge provides five indications of battery
level.
When the battery is depleted to the point of automatic
shutoff, the lowest gauge light will blink indicating the
need to recharge immediately. Of course, the bicycle can
still be ridden with the system turned off.
Due to the way the battery gauge measures charge, the
indicator lights may fluctuate while riding based on the
motor’s current load.
The best indication of remaining battery life is to check the
battery level gauge LEDs after reaching cruising speed
on a smooth, flat, straight road. This will allow the battery
voltage to stabilize and will give a much more accurate
reading.
the button controls motor
assist power
The PAS system provides three assist levels, which can
be cycled between using the ‘/-’ button.
Each level of assist corresponds to a maximum motor
speed; at level 3, the motor runs at full power. Overall
range decreases at higher power levels.
The system defaults to the lowest assist level at startup.
The motor will activate when the system senses the rider
pedaling. It is not possible to activate the motor without
turning the cranks.