Currier Tech Ezip, Руководство пользователя, Страница: 23 / 123

23
Reflectors
Your bicycle is supplied with one front (white), one rear (red), two wheel (white), and four pedal (orange) reflectors. These
are an important safety and legal requirements, and should remain securely fitted and in good, clean condition at all times.
Periodically inspect all reflectors, brackets and mounting hardware for signs of wear or damage. Replace immediately if
damage is found. Some bicycles will require you to install your reflectors onto your bicycle. Please refer to the following section
for instructions on all the types of bicycle reflectors.
Fork Mount Reflector Bracket assembly
First insert one washer onto the hex bolt and insert hex bolt through the reflector bracket and then
through the fork. Next, insert a second washer onto the bolt and thread a hex nut onto the bolt
behind the fork. Tighten bolts until snug, making sure the reflector is in an upright position. See
diagram at the right.
Front Reflector Mount with handlebar Bracket assembly
First attach the reflector to the reflector bracket with the reflector screw, if not already done. Next,
remove the clamp screw and open the reflector clamp bracket. Place reflector clamp bracket around
the handlebar. Tighten the clamp screw to hold reflector assembly in place. Finally, adjust the
reflector assembly in place and ensure that it is upright and facing away from the bike.