17
8.
INSTALL THE
RETURN CLIPS
Install the
return clip
s before installing the track onto the
camlocks. See Figure 19.
9. INSTALL THE TRACK
Figure 21 - Use clips to hold up track.
Once each hole has been pre-drilled on the extrusion, hold the track
into the extrusion and, starting in the middle, snap the temporary
retaining clip into the extrusion to hold up the track. Use a clip in the
center, on each end, and periodically in between as needed based on
track length.
Once the track is temporarily secured, permanently attach the track
to the extrusion by screwing through each of the pre-drilled holes.
PLEASE BE SURE TO USE THE PROVIDED SCREWS. DO NOT USE
THIRD PARTY SCREWS.
NOTE: On Ripplefold and Pin Ripple tracks, be very cautious to
avoid the carrier string during this process. Damage to the carrier
string will result in having to replace the entire string of carriers.
Figure 20 - Snap in pin connector
Figure 19 - Pin connector placement options
Choose one or more connection points on the top of the track
end, then snap the
return clip
into the chosen recess or recesses.
See Figure 20.
Once the track is installed, remove the temporary retaining clips.
Figure 21 - Permenantly secure track to recessed extrusion.
10. REFER TO PAGE
8
TO INSTALL MOTORS.