12
Figure 2.8.4.1 - Run wire to power & communication port
8.4 -
On units with power and control over CAT5
, run the wire as
desired to the power and communication port. See Figure 2.8.4.1.
Figure 2.8.4.2 - Plug ethernet cable into bottom of Sensor Box or Motor
Plug the cable into the port at the bottom of the sensor box housing
or motor. See Figure 2.8.4.2.
9. SET DEFAULT OPEN AND CLOSE LIMITS
Now that your track is installed and power has been applied, the
track needs to find its default close limits. Pull down and release
the pendant to send the curtain to the full Close position. Once the
curtain has reached this limit and has had a hardstop, pull down
and release the pendant to send the curtain to the default Open
position. From the default Open position, you can now set a
custom Open position.
You can now move on to custom programming.
Be sure to secure any excess cord, leaving no more than 8 inches unsecured, to reduce the risk of child strangulation.
