CSI Wireless SBX-3, Справочное руководство

Страница: 87 / 110

SBX-3 Reference Manual
69
MTP Message throughput
Q Quality number {0-25} – number of successive good 30 bit RTCM words
received
ID Beacon ID to which the receiver’s secondary channel is tuned
H Health of the tuned beacon [0-7]
T $PCSI,1 status output period {0-99}
Optionally, the Status Line B query can be modified to request the
output of the response message once every period. It has the
following format, where T is the output period in seconds.
$PCSI,2,T<CR><LF>
Response:
$PCSI,ACK,2
$PCSI,CS0,PXXX-Y.YYY,SN,fff.f,M,ddd,R,SS,SNR,MTP,Q,ID,H,T
The response message has the same format as discussed above.
The Status Line B message output cannot be set to remain active after
the power of the SBX-3 has been cycled.
The $PCSI,2 query may be sent through the either serial port for
reporting of the full status of the secondary receiver channel. The
response to the query will be returned to the port that the command
was issued. When querying the secondary receiver channel using the
secondary serial port, no interruptions in RTCM data output will occur
on the primary port, provided that SBX-3 has acquired a valid beacon.
5.7.2.4 Receiver Search Dump ($PCSI,3)
This query commands the SBX-3 to display the search information
used for beacon selection in Automatic Beacon Search mode. The
output has three frequencies per line.
$PCSI,3<CR><LF>