Crown Broadcast FME 350W to 2000W User Manual– 05/2013
Page 80
Crown Broadcast, a division of International Radio & Electronics Corporation 25166 Leer Drive, Elkhart, Indiana, 46514-5425 USA
Ph +1 (574) 262 8900
6.2.9. Status
commands
NAME
Access
(R/W)
Possible value on the
serial port of the unit
Comments
STAT.10M
R
"PRES" or "NOT PRES" Indicates the presence of an external 10 MHz
STAT.1PPS
R
"LOCK" or "UNLOCK"
Indicates the presence of an external 1 PPS
STAT.CLK R
"INTERNAL" or
"EXTERNAL"
Indicates the 10 MHz switch position
STAT.CURRENT.IN R
"1+OPT" or "1+2" or
"2+OPT"
Indicates the channels used for channels 1 and 2
STAT.DCOK1
R
"ON" or "OFF"
Indicates if the PSU 1 of the amplifier is "ON" or
"OFF"
STAT.DCOK2
R
"ON" or "OFF"
Indicates if the PSU 2 of the amplifier is "ON" or
"OFF"
STAT.DCOK3
R
"ON" or "OFF"
Indicates if the PSU 3 of the amplifier is "ON" or
"OFF"
STAT.DCOK4
R
"ON" or "OFF"
Indicates if the PSU 4 of the amplifier is "ON" or
"OFF"
STAT.INTERLOCK
R
"CLOSE" or "OPEN"
State of the safety loop
STAT.LINK
R
"OPEN" or "CLOSE"
State of the CAN bus link
STAT.PLL
R
"LOCK" or "UNLOCK"
Indicates the state of the exciter PLL
STAT.SECPIN
R
"ON" or "OFF"
Indicates if the input power is greater than the
hardware threshold
STAT.SECPREF
R
"ON" or "OFF"
Indicates if the reflective protection is enabled
STAT.SECTEMP
R
"ON" or "OFF"
State of the temperature safety
STAT.SWRF
R
"ON" or "OFF"
State of the RF switch
6.2.10. Communication board commands
NAME
Access
(R/W)
Possible value on the serial port
of the unit
Comments
CAN R/W
ID,CMD,DATA ; ID=[0…9];
CMD=[0…FF] DATA=[0..9 ; A…Z]"
Gateway between the serial port and the CAN bus.
ID=recipient’s address; TABLE=table containing the
command; CMD=command number; DATA=parameter
value. The list of tables/commands is available on request.
CAN.SCAN
R/W
Returns the list of units present of the CAN bus.
Commands related to options are only available when the option is present.
