Cronyx E1-XL/B-IP, Инструкция по установке и эксплуатации

Страница: 38 / 48

E1-XL/B-IP Multiplexor
© 2006 Cronyx
4.3.6. Menu “Configure | Console”
Menu “Configure | Console” is used to set up device console parameters and specify
possible access techniques:
Cronyx TDM/IP Trunk 1.0
Configure, Console: access password, console, ssh
0) Return
1) Password - change password
2) Hostname: DEMO - device’s hostname
3) Network: On - configure access from a network
4) Serial: 115200 - configure UART-console
5) Reset - reset password & set defaults
Command>
Password
It is used to set up password for accessing device console. Access via network (by
means of SSH) is possible only in case if specified password is not empty.
Device access recovery
In case access password is lost it is possible to recover access to device only locally
by employing access recovery procedure. To do so proceed as follows:
Connect VGA monitor and PS/2 keyboard to device;
Reboot device and control boot process on monitor;
When “Running startup procedures...” message appears press and hold “ALT”
key;
After several seconds device will request confirmation “Are you sure to reset all
settings?”;
If necessary confirm reset of all settings including access password.
Attention! Configuration and all records of device operation will be lost.
Hostname
It is used to set up device name which will be displayed during device boot and con-
nection to console.
1.
2.
3.
4.
5.