Crary Air Reel, Руководство пользователя, Страница: 43 / 60

PN 12071 R122210
39
OPERATION
5. Ensure cylinder stops are installed as needed (See
Section 5.2.1).
5.4.2 AFTER OPERATING FOR 2 HOURS
1. Re-torque fasteners and hardware.
2. Check that all safety decals are installed and legible.
Apply new decals if required.
3. Check that no hydraulic hoses are being pinched,
crimped, or are rubbing. Reroute as required.
4. Check that the wiring harness is not being pinched,
crimped, or rubbing. Reroute as required.
5. Check the tension and alignment of all drive chains.
Adjust as required.
6. The gearbox will generate heat. The typical operating
temperature of the gearbox is 180° F.
5.4.3 AFTER OPERATING FOR 10 HOURS:
1. Re-torque fasteners and hardware.
2. Check that all guards are installed, secured and func-
tioning as intended. Do not operate with missing or
damaged shields.
3. Check safety decals. Install new ones if required.
4. Check the routing of hydraulic lines and the wiring
harness. Reroute as required to prevent pinching,
crimping, binding, or rubbing.
5. Check the plastic eccentric rollers for uneven wear.
6. Refer to the normal servicing and maintenance sched-
ule as defined in the Service Record.
5.5 CONTROLS
Before starting to work, all operators should familiarize
themselves with the location and function of the controls and
safety devices. Some machines may vary due to different
models of combines and headers.
MANIFOLD TILT:
1. Moving the toggle switch to the FORE position (Figure
43 & Figure 44) extends the shaft of the electric actuator
forward. This rotates the manifold CW which directs the
air tubes towards the front of the header. See Section
5.2.1 for the center stroke position which points the air
tubes directly behind the cutterbar.
2. Moving the toggle switch to the AFT position (Figure 43
& Figure 44) retracts the shaft of the electric actuator
backward. This rotates the manifold CCW, which directs
the air tubes towards the back of the header.
Figure 44: Manifold tilt/air movement
AIR MOVEMENT AIR TUBE
CUTTERBAR
MOVING TOGGLE TO "FORE"
POSITION, DIRECTS AIR
TUBES TOWARD BACK
OF HEADER.
MOVING TOGGLE TO "AFT"
POSITION, DIRECTS AIR
TUBES TOWARDS FRONT
OF HEADER.
Figure 43: Manifold tilt/air volume toggle switch
MANIFOLD TILT
TOGGLE SWITCH
FAN AIR VOLUME
TOGGLE SWITCH
5.4 MACHINE BREAK-IN