Crary Air Reel, Руководство пользователя

Страница: 32 / 60

PN 12071 R122210 28
ASSEMBLY
4.18 AIR HOSE
For easy installation of hose parts, you may use a solu-
tion of soap and water as lubricant when sliding pieces
together.
NOTE
1. Position the hose connector weldment on top of the
hollow beam at the back of the header as shown in
Figure 33. The weldment should be positioned 3.5”
from the right edge of the beam and 1” from the back
edge of the beam.
2. Mark and drill two 11/32” holes for the hose connector
weldment.
3. Install the hose connector weldment with two 5/16” x
1” bolts and serrated flange nuts. Torque to 17 ft-lbs.
4. Use the top two holes of the hose connector weldment
to relocate the OEM light.
5. Place an 8-11/16” t-bolt clamp over each end of the 45
degree elbow (Figure 34).
6. Slide the 45 degree elbow over the air outlet of the fan.
Point the elbow toward the hose connector weldment.
7. If your right hand drive kit includes a 4’ flex hose piece,
insert the elbow support band from the 4’ flex hose into
the 45 degree elbow. Otherwise, insert an elbow support
band from the 8’ flex hose into the 45 degree elbow.
Figure 33: Hose connector weldment
8. Determine the length of flex hose needed to reach the
hose connector weldment and cut the hose as needed.
Do not leave slack in this portion of flex hose.
9. Slide the flex hose and an 8-3/8” t-bolt clamp onto the
back end of the hose connector weldment.
10. Place an 8-11/16” t-bolt clamp over each end of the 90
degree elbow.
11. Slide the 90 degree elbow over the reel manifold. Point
the elbow toward the hose connector weldment.
12. Insert the elbow support band from the remaining piece
of flex hose into the 90 degree elbow.
13. With the remaining piece of flex hose, determine the
length of hose needed to reach the hose connector
weldment and cut the hose. Leave enough slack in
this portion of flex hose to allow the reel to fully extend.
14. Slide the flex hose and an 8-3/8” t-bolt clamp onto the
front end of the hose connector weldment.
15. Tighten all t-bolt clamps.
On some headers, the OEM light bracket is bolted to the
top of the header where the hose connector weldment
should be placed. In this case, remove the light bracket
from the header and install the hose connector weldment
in the existing holes. Then, bolt the OEM light bracket
to the top two holes of the hose connector weldment.
NOTE