Crary Air Reel, Руководство пользователя, Страница: 24 / 60

PN 12071 R122210 20
ASSEMBLY
4.10 AIR TUBES
1. Roll the manifold over so that the air tube holes in the
bottom of the manifold are at the 12:00 position.
2. Apply the self adhesive foam seals (Figure 18).
A. Remove and discard the slot and two hole
cutouts from the self adhesive foam seal.
B. Remove the self adhesive foam seal from the
backing and apply foam seal to manifold.
3. Assemble the single air tubes to the inside manifold
holes.
A. Locate three 11/32 X 7/8 self tapping screws
per each air tube.
B. Place an air tube on the manifold, aligning
the three small holes of the air tube with the
manifold.
C. Drive three 11/32 X 7/8 self tapping screws
through the air tube into the holes of the mani-
fold (Figure 19) You may use an impact wrench
for this step.
D. Follow steps A through D for the remaining
air tubes.
4. Install the double air tubes to the manifold outside holes.
Follow step 3 for installation instructions.
Make sure that the opening of the single and double
air tubes face towards the rear of Air Reel (Figure 20).
IMPORTANT
The double air tube assemblies are only installed on the
ends of the manifold (one per end) (Figure 20).
IMPORTANT
Figure 18: Apply self-adhesive foam seals
Figure 19: Fasten screws
Figure 20: Installation of air tubes
NOTE:
OPENINGS OF AIR
TUBES FACE TOWARDS
REAR OF AIR REEL.
AIR TUBE
WELDMENT
SELF TAPPING SCREWS
(3 PER AIR TUBE)
DOUBLE AIR TUBE ASSEMBLY
(1 EACH END OF MANIFOLD)
FOAM SEAL
(1 PER TUBE)
BACK OF
MANIFOLD