5. Fan Assembly.
page 4
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower
hanging ball and remove stop pin and then slide
hanging ball off of the downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor
housing yoke.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
[
Refer to
diagram 2
.
]
Determine the length of threaded downrod you
wish to use. Thread safety cable and electrical
wires through threaded end of downrod and pull
extra wire slack from the upper end of the
downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--
make sure wires do not get twisted
.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely.
[
Refer to
diagram 2
.
]
Locate canopy cover in hardware pack. Slide yoke
cover, canopy cover and canopy over downrod.
(
Note
: Canopy cover must be turned with shiny
side
toward
the motor housing.)
[
Refer to
diagram 3
.
]
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this
fan.
set screw
hanging ball
stop pin
diagram 2
diagram 1
diagram 3
clip
pin
canopy
motor
housing
yoke cover
canopy cover
downrod
downrod
electrical wiring
safety cable
yoke set screw
and nut
motor
housing
