page 10
13. Testing Your Fan.
12. Remote Control Operation.
ON/OFF
slider switch - turns
wall control
ON or OFF
(switch not functional on handheld remote)
HIGH
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
OFF
button - turns
fan
OFF
L
button - turns
light kit
ON/OFF when pressed once;
dims
light kit
when pressed and held down
wall control
CAUTION
:
The wall and/or handheld remote control can be programmed to multiple receivers or fans. If this
is not desired, turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON
position. Within 60 seconds of turning on the wall control, press and hold the fan
OFF
button on the
wall control for 5 seconds (or until light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds
and then turn power back on. Within 60 seconds of
restoring the power, press and hold the
OFF
button on the front of the handheld remote control for 5
seconds (or until light blinks twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is complete--
see Section 13 below.
handheld
remote control
11. Automated Learning Process./Activating Code.
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable). Test wall
control (optional installation) by locating ON/OFF slider switch on wall
control, then set to the ON position. Test light and dimmer function
and then test fan speeds. Next, locate handheld remote control. Test
the light ON/OFF function by pressing the L button; test the dimmer
function by pressing the L button and holding it down for 1 second.
Test fan speeds with the different fan speed buttons. If the wall and/or
handheld remote control operates all of the functions of the fan,
battery has been installed correctly. If the wall and/or handheld remote
control do (does) not operate all of the fan/light functions, refer to
"Troubleshooting" section to solve any issues before contacting
Customer Service.
Turn fan completely off
before
moving the reverse switch (located on
top of the motor housing). (
diagram 1
) Set reverse switch to recirculate
air depending on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat setting in summer
and lower your thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for fan to function. If the reverse switch is set in
the
middle
position (
diagram 4
), fan will not operate.
NOTE
: If the wall control/handheld remote control interferes with other
appliances, turn off power and go back to the instructions in
Section 12.
Reverse Switch
diagram 1
diagram 2 diagram 3 diagram 4
