page 8
9. Light Kit Assembly.
Remove 1 screw from motor plate (on
underside of motor) and partially loosen the
other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex
connections to come through center hole in
fitter plate. Twist fitter plate to lock. Re-insert
screw that was previously removed and
securely tighten all 3 screws with a Phillips
screwdriver.
[
Refer to
diagram 1
.
]
Remove 3 screws from post located on
underside of fitter plate.
Connect
WHITE
wire from motor housing to
WHITE
wire from the LED light kit and
BLACK
(or
BLUE
)
wire from motor housing to
BLACK
wire from LED light kit. Make sure molex
connections snap together completely.
[
Refer to
diagram 2
.
]
Carefully arrange wiring within LED light kit.
Align holes in LED light kit with holes from
post located on fitter plate. Re-insert screws
that were previously removed and securely
tighten all 3 screws with a Phillips
screwdriver.
[
Refer to
diagram 2
.
]
Align grooves on glass shade with nodules on
inside of fitter plate and push up gently on
glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade no longer turns.
[
Refer to
diagram 3
.
]
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
diagram 1
diagram 2
groove
nodule
diagram 3
motor housing
fitter plate
motor plate
LED light kit
molex
connections
fitter plate
motor housing
motor housing
molex
connections
post
glass shade
post screw
