CraftBot FLOW WIDE XL, Руководство пользователя

Страница: 44 / 58

SINGLE HEAD - USER MANUAL V1.2
44
Nozzle hand drill bits
These are used to help drill out the clogged nozzle during
the cleaning process.
There are 3 sizes:
• Ø 0,6 mm
• Ø 0,8 mm
• Ø 1 mm
Caution! Don’t use the drill to clean until the extruder is
heated to above 200°C (392˚F).
Alcohol prep pads
• Keep the Kapton foil cleaned whith alcohol prep
pads.
Caution! Avoid contact with the eyes and please keep
out of reach of children.
◊ After using this product for wiping, it will be
completely evaporated leaving and no residue after
about 30 seconds.
Wire brush
• Use the wire brush to clean the nozzle and the feed
gears.
• Don’t forget to heat up the nozzle before cleaning.
Caution! The brush head is made from copper wire, and
it is relatively soft. Therefore, the brush head may be
deformed or warped in transportation.
Wire cut
For trimming the model or cutting off the various 3D
printer filaments. Always cut a clean end before placing
the filament into the extruder gear.
Nozzle needles
For help in removing any excess plastic when clearing
jams from the nozzle and any other hard-to-reach places
like the feed gears.
There are 4 sizes:
• 0,25 mm
• 0,4 mm
• 0,6 mm
• 0,8 mm
Caution! The nozzle cleaning needles are sharp; please
keep them safe and out of the reach of children.