CORVUS 70E V2, Инструкция по эксплуатации

Страница: 10 / 29

ARF® MODEL
and other covering. Be careful not to apply too much heat or you may cause bubbles or damage to the
covering. A heat gun may also be used along with a soft cotton cloth to shrink and adhere the
covering . Again, be extremely careful when using a heat gun.
Some modellers prefer to seal the hinge gaps using strips of appropriate covering or clear trim tape.
We have found this to be helpful with models intended for higher speed flight or models with unusually
large hinge gaps. Aircrafts that utilize a very tight double beveled hinge line and do not normally
require this step. Sealing the hinge gaps is therefore left as an option formodellers .
Please verify the accessories before assemble:
•
4 fiber glass servo horns: 2 single horns for ailerons, and 2 for elevators (if you choose to use
single servo to control elevators, you only need to install one control horn and joint the
elevators with a fiber glass bar, please see instruction in “Elevators Assembly” section). 1 dual
horns for rudder.
*There is a layer of protection film on the horns. Please remove the film before installation.
•
Pushrods: 4 2x65mm pushrods for aileron & elevator.