Cornelius FCB - 2 Flavor, Руководство по обслуживанию

Страница: 57 / 76

Pinnacle 2 and 4 Flavor Service Manual
C
ONDENSER
F
AN
M
OTOR
R
EPLACEMENT
(I
NTEGRAL
O
NLY
)
C
ONDENSER
F
ILTER
R
EPLACEMENT
(I
NTEGRAL
O
NLY
)
11. Replace magnet into opening of cylinder. Use magnet removal tool to slowly and carefully push magnet to
back of cylinder.
NOTE: As magnet approaches end of cylinder the magnet force increases and care must be taken to
not let the magnet slam into the end of the cylinder.
12. Reinstall the beater bar and scrapper blades. Be sure the bushing is on the front of the beater bar shaft.
Make sure that the beater bar is engaged with the magnet.
13. Reinstall the faceplate by pressing until it contacts the front of the cylinder and then install the washers and
nuts (finger tight only).
14. Re-connect the power and go through the normal start-up procedure.
1. Disconnect the power to the unit. Remove top cover (1 screw).
2. Unplug motor wiring harness and remove air filter.
3. Remove 4 screws securing fan shroud to frame.
4. Lift fan motor and shroud out.
5. Remove 4 screws securing fan motor to shroud.
6. Remove 2 fan covers and place them on the new fan.
7. Reverse the procedure to install new motor.
FIGURE 68
1. Slide filters out of tracks right and left side.
2. Clean or replace.
3. Re-install.
FIGURE 69
Screws
© 2003-2014, Cornelius Inc. - 53 - Publication Number: 560007298SER