Cormach MEC 200 TRUCK, Руководство по эксплуатации и обслуживанию

Страница: 36 / 44

Use and Maintenance Manual – 09/2016 Rel. 0 Page 30
19. SERVICE MODE
In this mode, the machine allows the user to enter certain settings (for example, selection of the units of measurement) or use special
testing programs (to verify machine functioning) or configuration.
Some test and configuration programs are included in this Menu while the setting programs are available with direct access by means
of the buttons. See tableT13.2 to consult the full list of settings, programs and menus available in the SERVICE mode.
Note: some test or configuration programs are not available to the end user but only to technical support personnel.
To access the SERVICE mode, proceed as follows:
1. Switch the machine on and wait for completion of the initial test. After running the initial test, the machine will be in the
NORMAL mode;
2. Press [F+P3] keys . The machine enters the SERVICE mode and will display the
Ser Ser
messages.
See figure F19.1;
Figure F19.1: SERVICE mode enabled
3. To exit the SERVICE mode, you must first exit any Menus and test programs and return to the messages display shown in
figure F19.1;
4. Press [F+P3] keys : the machine will return to the NORMAL mode.
[P2] Not used
This button is not currently used in SERVICE mode.
[P3] Machine calibration
This button allows you to access the machine calibration procedure as described in detail in section “14. Machine calibration” .
[P4] Select grams/ounces
This button allows you to display and/or change the unit of weight currently selected. The units available are grams (
GRAM
) and
ounces (
OUNCE
).
DISPLAY OF CURRENT UNIT
To display the current unit of measurement, briefly press [P4] . The unit selected is displayed for three seconds, after which
the machine returns to display
Ser Ser
.
CHANGE OF CURRENT UNIT
To change the current unit of measurement, keep [P4] pressed for three seconds. The new unit of measurement will be
displayed, after which the machine returns to display
Ser Ser
.
The unit of measurement selected is maintained even after turning off the machine.