Cormach MEC 200 TRUCK, Руководство по эксплуатации и обслуживанию

Страница: 41 / 44

Use and Maintenance Manual – 09/2016 Rel. 0 Page 35
(1)
The error code can be exited in the following ways:
OPERATOR
CONFIRMATION
The machine exits the error code display when the operator presses any key (except for [P7] ).
OPERATOR ACTION
The machine exits the display of the error code when the operator takes an action related to the error
code itself.
ONCE
The machine displays the error code and its brief description just once, then it returns to the previous
status.
PERMANENT
The machine permanently displays this error code until being turned off, therefore the error code cannot
be exited.
20.2 Acoustic signals
The machine emits different acoustic signals based on its status. The acoustic signals are listed in table T20.2.
Table T20.2: Acoustic signals
Signal Meaning Notes
Short beep Selecting a program or a function.
Double beep Warning.
A particular condition has occurred that requires the
operator’s attention.
Triple beep Function not available or Error.
The requested function is not available or an error
condition has occurred.
Short Beep + Long beep
Storing one or more values in the permanent
memory (eeprom) of the circuit board.
One or more values have been stored in the permanent
memory of the circuit board (for example, at
completion of calibration phases).
Intermittent beep Adjustment.
Signal used in some service programs to semplify the
adjustment of sensors.
The acoustic signal is also heard for about two seconds at machine start-up allowing the operator to check the operation of the alarm
(buzzer).
20.3 Special visual signals
The machine gives special visual signals in certain cases. The special visual signals are listed in table T20.3.
Table T20.3: Special visual signals
Signal Meaning Notes
Three dots lit on one or
both displays Imbalance exceeds 999 grams. This signal can be triggered due to:
•
Lack of machine calibration;
•
Incorrect measures of the wheel dimensions;
•
Incorrect setting of the Wheel Type;
•
Incorrect setting of the Program Type.
Flashing green STBY LED The machine is in the STAND-BY mode. All LEDs and displays are switched off. To exit the
STAND-BY mode press any button
(except for [P7] key ).
The left (or right) display
is flashing Attending the user’s command. The user’s command may be pressure of a key to
confirm or continue the procedure in progress or the
selection of a value or a menu option.