Cormach MEC 200 TRUCK, Руководство по эксплуатации и обслуживанию

Страница: 22 / 44

Use and Maintenance Manual – 09/2016 Rel. 0 Page 16
Note: the keys [P7] , [P8] Start and [P10] Stop are not used to access settings, programs or Menus.
13.2 Operating modes STANDARD, SERVICE, STAND-BY
The machine features three operating modes:
•
STANDARD mode. This mode is enabled after the machine is turned on and it is possible to perform the wheels balancing;
•
SERVICE mode. In this mode various utility programs are available for setting parameters (such as grams or ounces) or
checking the machine operations (such calibration);
•
STAND-BY mode. After 5 minutes without user activity, the machine automatically switch to STAND-BY mode to reduce
electrical consumption (both with wheel guard raised or lowered). The STAND-BY green led on the control panel is blinking
it means the machine is in this operating mode. All acquired data and settings are held in STAND-BY mode. In the SERVICE
mode is not possible to switch to STAND-BY mode.
To exit from STAND-BY mode choose by any of the following means:

Press any keys (with the exception of [P7] );

Turn manually the wheel.
Note: the machine exits the STAND-BY mode also by pressing the key [P8] Start . In these cases simultaneously the spin will
start.
14. MACHINE CALIBRATION
To operate properly, the machine must be calibrated. Calibration allows storing the mechanical and electrical parameters specific to
each machine so as to provide the best balancing results.
14.1 When to carry out machine calibration
Table T14.1 lists the cases in which machine calibration should be carried out. Calibration must be carried out whenever one or more
of the conditions listed are active.
Table T14.1: Conditions for carrying out machine calibration
Condition Status Who must perform it
When the machine is installed at the final user's site Mandatory Technical Service
When the electronic circuit board is replaced Mandatory Technical Service
When a mechanical part linked to the pick-up signal (pick-up, pick-up compression
springs, suspension unit + shaft) is replaced Mandatory Technical Service
When the pick-up compression spring adjustment is modified Mandatory Technical Service
When the encoder disc is replaced Mandatory Technical Service
When the machine does not provide the best balancing results Recommended Final user and/or
Technical Service
When there are large, constant variations in the environmental humidity and
temperature conditions (for example seasonal changes) Recommended Final user and/or
Technical Service