Cormach MEC 200 TRUCK, Руководство по эксплуатации и обслуживанию

Страница: 25 / 44

Use and Maintenance Manual – 09/2016 Rel. 0 Page 19
8 Mount the wheel on the shaft and enter the wheel dimensions
by pressing the [P1] , [P2] , [P3]
to select the dimensions to change, and the [P4] or
[P5] to edit the value. If the dimensions of the
wheel have been entered before accessing the calibration
program, this step can be skipped.
Press [P8] key Start . The machine will run a launch.
9 At the end of the launch, manually rotate the wheel until the
left display shows the value 50. On the inner side of the wheel,
at 12 o'clock, apply the 50 gr. weight.
10
Press [P8] key Start . The machine will run a launch.
11
Remove the 50 gr. weight applied on the internal side.
12 Manually rotate the wheel until the right display shows the
value 50. On the outer side of the wheel, at 12 o'clock, apply
the 50 gr. weight.
13
Press [P8] key Start . The machine will run a launch.
14 Calibration is finished: the machine automatically exits the
calibration program and returns to NORMAL mode, ready to
perform balancing.
If there are anomalies during the calibration procedure the machine will display an error message (for example
Err 025
). See the
paragraph “20.1 Error Codes” to solve the problem and continua/repeat/cancel the calibration procedure in progress. The spins
interrupted by pressing [P10] key Stop or by rising the wheel guard (when present) may be repeat by pressing [P8] key
Start or lowering the wheel guard (when present).
How to exit the CAR/SUV or TRUCK wheel type calibration
At any time it is possible to exit the calibration procedure by pressing [F+P3] keys . The machine will return
to SERVICE mode displaying the writing
Ser Ser
. To return to the NORMAL mode, press [F+P3] keys
again. The calibration procedure in progress will be cancelled and the results will use previous calibration values.