27
Troubleshooting Guide
Corinex HD200 CableLAN Wall Mount
8
Troubleshooting Guide
The Corinex HD200 CableLAN Wall Mount has been designed to be a reliable
and easy-to-use network connection device. Please refer to the list below to aid in
troubleshooting.
The AP LED is off.
1. Make sure the power adapter is plugged directly into the electrical outlet, and
that the outlet has power.
2. Try another outlet.
The VPI LED is red (low or no connectivity between adapters).
1. Make sure the coaxial cables on all adapters are properly installed (the
connector on the coaxial cable must be firmly screwed to the F-type
connector on the device).
2. Make sure the IEC connector is correctly connected to the coaxial outlet (if
using a coaxial diplexer both the IEC connector and diplexer have to be
correctly connected).
3. Try another coaxial cable and/or coaxial outlet.
The ETH LED is off.
1. Make sure the adapter is connected with an Ethernet enabled device
with a Cat 5E/6 cable (with RJ-45 connectors). and both devices are powered
on.
If the trouble persists, please visit
www.corinex.com
and go to the appropriate
section for information about your product. There you will find news, manuals and
software updates, as well as frequently asked questions (FAQ).
To avoid personal injury and damage to the system:
1. The principal method to disconnect the device completely from the
electrical power network is to unplug the device from the electrical socket.
2. Never install the unit in wet areas or next to radiators/heaters.
3. Never use the unit outside.
4. Unplug the unit during severe storms.
5. Never open the equipment enclosure.
If after using the information sources listed above, you still are not able to find a
solution to the problem you are experiencing, please send us a description of the
problem via
http://www.corinex.com/support/technical-support
.
We will need
as much information as possible about your devices and your network setup in order
