11
Installation Guide
Corinex HD200 CableLAN Wall Mount
2.7 Factory Default Modem Configuration
All Enterprise modems are set to run the auto-configuration process by default.
This process uses DHCP and TFTP to obtain the network settings and modem
configuration. It also uses a proprietary protocol called PTTP to communicate with
the management VLAN.
2.8
Installing the Corinex HD200 CableLAN Wall Mount
If your network uses a xDSL modem to connect to the Internet please proceed to
section 2.8.1. If your network uses a Cable modem to connect to the Internet please
proceed to section 2.8.2.
2.8.1 Installing the Corinex HD200 CableLAN Wall Mount: xDSL
environment
The Corinex HD200 CableLAN Wall Mount will need to be installed in a network
topology similar to the diagram shown below. Please note some steps may vary
depending on your network topology, IP address settings etc.
