Air Source Heat Pump Water Heater
24
10 Wired Controller Installation
10.1 Requirements for Wired Controller Installation
Locations
(1)
Do not install the wired controller in a wet place or a place exposed to
direct sunlight.
(2)
Do not install the unit or wired controlled of the air source water heater in
a place susceptible to electromagnetic interference.
(3)
Ensure that the communications line is connected to the correct interface.
Otherwise, communication will failure.
10.2 Wired Controller Installation
Figure 10-1 is a simple diagram for installing the wired controller. Note the
following issues for installation:
(
1
)
Before the installation, cut off the power supply to which the strong wires
buried in mounting holes of the wall are connected. The power supply must be cut off
during the entire installation process.
(
2
)
Pull out the 4-core twisted pair from the mounting hole of the wall, and lead
the 4-core twisted pair through the rectangular hole behind the baseplate of
the wired controller.
(
3
)
Attach the baseplate of the wired controller to the wall, and use an M4X25
screw to fasten the baseplate to the mounting hole of the wall.
(
4
)
Insert the 4-core twisted pair that passes through the hole into the slot on
the wired controller, and buckle the wired controller panel and the wired controller
baseplate together.