5
Safety chain anchors
In order to eliminate the risk of the cooker falling forward, two chains have been installed at the rear of the
cooker. Before use, these will need to be fastened securely to the wall behind the appliance with the
anchor brackets supplied. (Figure 2):
1.
Decide on a suitable wall location for fitting the anchor brackets directly behind each cooker safety
chain (Figure 2).
2.
Hold the chain anchor up to the wall where it will be required, and mark the fixing holes. (Figure 2).
3.
Drill the fixing holes and fix the chain anchors to the wall using the screws provided and suitable wall
plugs for the type of wall being fixed to.
4.
Leave the chains unattached until the installation process has been completed.
Figure 2 - fixing an anchor bracket
SCREWS
ANCHOR
BRACKET
WALL
PLUGS
FIXING
HOLES
Electricity supply
Once a satisfactory location has been established, the electrical supply to the appliance must be arranged.
The mains voltage must correspond to that which is specified on the data plate.
The supply should be from a 45 amp fused spur, with an isolator switch installed above the work surface
and to one side of the unit in case of an emergency. The isolator switch must have working contacts
separated by 3mm.
This installation must be carried out in accordance with current I.E.E Wiring Regulations and Building
Regulations (Part P).
The mains supply cable from the isolator to the unit must be rated for the maximum power consumed by
the unit (also specified on the data plate).
The supply cable must be long enough to allow for servicing the appliance.
The supply cable must be routed away from hot surfaces.
Gas supply connection
PLEASE NOTE: Connection of the gas supply, adjustment, cleaning and tap servicing should ONLY
be carried out by a CORGI registered gas fitter or qualified service engineer, in accordance with the
latest regulations.
There are two installation options:
Connection to natural gas supply
The cooker comes ready for connection to a piped supply of natural gas, and should only be connected by
a CORGI registered gas fitter or qualified service personnel, in accordance with the latest regulations.
