CONVEY-ALL 1214-GN, Руководство оператора

Страница: 43 / 56

4-9 Revised 02.2021
Operator’s Manual: Transfer Conveyor
4.3.3 Conveyor Belt Replacement:
1. Rotate the conveyor belt until the Alligator®
lacing is positioned under the tube and is
accessible.
2. Move the tail roller bearings to their loosest
position.
3. Pull all the slack to the seam area.
4. Remove the lacing rod and open the belt.
5. Attach the new belt to the end of the existing
belt which is hanging closest to the hopper.
6. Pull the end of the old belt which is coming
from the direction of the discharge hood.
The new belt will follow and be threaded into
place.
7. Disconnect the old belt.
8. Link the ends of the new belt lacing.
9. Work the lacing cable through the lacing to
fasten the belt.
Note:
Cordless drill can be used to thread cable.
Proceed slowly.
10. Cut off the excess cable.
11. Crimp lacing at both ends to lock cable in
place.
12. Cut and taper the trailing corner of the belt.
- This will keep the hole as small as possible.
- Tapered corner won’t catch when running.
13. Set the belt tension. Refer to Section 4.3.1
14. Set the belt alignment. Refer to Section
4.3.2.
Fig 52 - Tail roller bearing housing
Fig 53 - Conveyor belt seam under tube
Fig 54 - S-Neck belt path
Fig 55 - Belt lacing
Belt Travel
Direction