CONVEY-ALL 1214-GN, Руководство оператора

Страница: 31 / 56

3-13 Revised 02.2021
Operator’s Manual: Transfer Conveyor
• Keep the hopper full for maximum capacity.
Most efficient results will be obtained when
flow of incoming product is directed at the top
of the hopper (closer to the tube).
• Always listen for any unusual sounds or
noises. If any are heard, stop the machine and
determine the source. Correct the problem
before resuming work.
• The machine is available in 10” and 14”
diameter tubes, as well as 16” and 22” belts.
The larger the tube and wider the belt, the
higher the capacity will be.
• Never allow anyone into the workplace hazard
area. If anyone enters, stop immediately. The
visitor must leave before resuming work.
• Position discharge hood appropriately for the
application. Refer to page 3-6
• Belt Speed:
The best results are obtained when the input
drives are set to provide a belt speed of 400
to 500 ft/min.
Count the number of belt revolutions per unit
time to determine belt speed. Use the lacing
as a reference when counting belt revolutions.
Contact your dealer or the factory for the
appropriate drive components to give the
recommended belt speed.
• Do not run the machine for long periods of time
with no material on the belting. This increases
the wear. Try to run only when moving material.
• Keep the hopper full for maximum capacity.
• Most efficient results will be obtained when
flow of incoming material is directed to the
front of the hopper (closer to the tube).
Fig 30 - Feeding the hopper
• Belt Tension:
There may be a rapid decrease in belt tension
during the first few hours of operation until the
belt has worn in.
The correct operating tension is the lowest
tension at which the belt will not slip under
peak load conditions.
• The hopper is designed with flashing to seal
the junction of the belt with the sides of the
hopper. It must be kept in good condition to
prevent the material from “leaking” out of the
hopper. Replace flashing if “leakage” occurs.
3.8 OPERATING HINTS