Contec FX-DS540-AP, Руководство пользователя, Страница: 54 / 99

4 Setup Preparation
FX-DS540-AP, FX-DS540-APP 45
Connecting to the Web Browser PC
When using a web browser to setup the AP, you can connect via either a LAN or a modem. Use the
following procedure to connect the web browser.
Connecting via a LAN
(1) Connect the PC on which you will run the web browser to the same network as the AP.
Alternatively, you can use a UTP cable to connect the PC directly to the AP. In that case, use a
crossed-cable.
The connection will not work if you use a standard straight-through cable.
CAUTION
You may not be able to establish a connection if the web browser is setup to use a proxy. In this case,
change the setting to not use a proxy.
Remember to change the proxy setting back when you have finished setting up the AP.
Connecting to an FX-DS540-AP/APP
To connect the web browser to the AP, the IP address of the PC on which you run the web browser must
be in the same network group as the IP address of the AP. The factory default IP address set in the AP is
always in the class A network group starting with [10] (that is, 10.xxx.xxx.xxx). Accordingly, set the IP
address of the PC to also start with [10] ([IP 10.1.1.1, MASK 255.0.0.0], for example). Remember to set
the IP address of the PC back to its previous value after you have finished with the connection for setting
up the AP. When setting up the AP, it is recommended that you change the IP address of the AP.
(1) Start the web browser
Recommended web browsers are Microsoft Internet Explorer 5.01 or later and Netscape Navigator
6.0 or later.
(2) After starting the web browser, enter the IP address of the AP in the URL field.
For example, if the IP address of the AP is [10.66.1.1], enter the following:
http://10.66.1.1 /
Refer to Chapter 5 below as you perform software setup.