Contec FX-DS540-AP, Руководство пользователя, Страница: 39 / 99

3 Setup
30 FX-DS540-AP, FX-DS540-APP
Wall Installation
The attached wall mount screws are useful for installing the unit on a wall. Attach the unit to a stable
vertical wall and ensure that adequate space is provided for ventilation (5cm). As far as possible, locate
the unit in a high place with an unobstructed view as this gives better radio transmission and reception
performance and increases the operating range. Also, locating the unit (antenna) too close to concrete or
metal walls (including steel frames) causes a reduction in communication quality. If mounting the unit
on a metal or concrete wall, ensure a gap of at least 30cm from the wall.
115mm
103.4mm
94mm
Wall mount holes
The provided wall-
mount fittings
Screws
Figure 3.6 Wall Installation
To mount the unit on a wall, obtain the required number of screws (to fit
φ
3.5).
(1) Use the screws to attach the provided wall-mount fittings to the wall. The dimensions are shown in the
figure above. (4 locations)
(2) Attach the AP case such that the four wall-mount fittings on the wall insert into the wall-mount holes
on the case.
(3) Slide the AP unit down to hold it in place.
CAUTION
Do not obstruct the ventilation slits. This can cause the temperature inside the product to rise and
can damage the components inside.
WARNING
The FX-DS540-AP/APP must be installed with the top or side
surface face up. If installed with any other surface face up,
the AP can be overheated inside to catch fire.
Top
Side