Conergy TS, Инструкция для владельца и по установке

Страница: 31 / 36

E
N
G
L
IS
H
Conergy TS
Owner & Installation Manual
Commissioning & Customer Hand Over
When all connections have been completed the solar water heater can be filled with water.
|
|
|
|
|
|
|
Customer Hand Over
The solar water heater is now fully operational.
Once the solar water heater is commissioned and you are confident it is operating correctly, complete
the installation details on the carbon copy sheet at the beginning of the owners manual. Please
remove the Conergy (blue) and the installer (pink) copy. Please hand the owner the Owners Manual
and Gas Heater Manual (if gas AES is used).
Before leaving the installation ensure that the customer is fully aware of the systems operation and
whom to contact should there be any questions in the future.
Thank you for installing our world class Conergy solar water heater.
Your Conergy Team
Before turning on the cold water supply open one hot tap within the household to release air
from the system during the filling process. Do not leave the open tap unattended during the filling
process.
Turn on the cold water supply and wait for the system to fill.
When water flows from the open hot tap without air bursts then the hot tap can be closed. This
will now pressurise the solar water heater system.
Once the system is pressurised all connections on the water heater must be checked for leaks
and repaired if necessary.
When the system is proven water tight, power and gas can be applied to the AES system.
To test that the element is operational turn the circuit breaker in the switch board on and off, you
should see the power meters speed change during this action.
For gas AES systems turn on a hot water tap and the gas heater will ignite provided the water
temperature is less than 60 °C.
Commissioning & Customer Hand Over