Conductix-Wampfler Jay Electronique Jump, Инструкция по установке и эксплуатации для пользователя

Страница: 46 / 81

- 46 -
Jump - 332970E_A005
04/03/21
FR EN
The Jump radio repeater is designed for use with the JAY Electronique
radio control solutions implementing unidirectional transmission.
The Jump radio repeater is used to relay a radio signal on a channel
chosen by the user.
The Jump radio repeater provides a solution for applications in difficult
environments (obstacles, troughs, bumps) where a direct link is not
possible, and in situations where radio performance must be extended to
cover a greater distance or greater area.
The repeater is paired with a device by «learning» procedure (registration
in the repeater of identification code of the equipment with which it is
operating).
The repeater waits for the n correct radio frames generated by a radio
transmitter, stores them, then re-transmits the n (1 ≤ n ≤ 10) correct
received frames. No radio transmission takes place if any incorrect frame
is received, or if the ID code sent has not been programmed into the
repeater Jump.
Important : This operating principle naturally creates a delay. this delay
must be taken into account and added to the system.
See «
Configuration
»
section.
two operating choices are available:
• 1° The repeater transmits on the same radio channel on which it is
receiving (see example of use # 1 and #2)
• 2° The repeater transmits on a different radio channel than the one
on which it is receiving, in this case, transmission radio channel
No = reception radio channel No +10. (See example of use # 3)
3 - Operating principle