Conductix-Wampfler Jay Electronique Jump, Инструкция по установке и эксплуатации для пользователя

Страница: 54 / 81

- 54 -
Jump - 332970E_A005
04/03/21
FR EN
4.2.4- Choice of operating mode (choice of transmission channel
relative to the reception channel)
Two radio operating modes are available. The choice of operating mode is
performed using the DIPswitch « configuration » and cursor No. 5.
Mode 1 :
«Transmitter / repeater Jump / Receiver» system operates with the same radio
channel.
The received radio signal on the radio channel No. x is repeated on the radio
channel No. x . This operating mode is limited to a single repeater.
Caution: Never use multiple repeaters in mode 1 on the same «Transmitter
/ Receiver» pair. Except recommendation of Operating principle Nb 2. See
« Operating principle » section.
Mode 2 - 433MHz and 915MHz frequency ranges :
«Transmitter / reception Jump and transmission Jump / Receiver» system
operates with two different channels.
The received radio signal on the radio channel No. x is retransmitted on channel
No. y where y = x +10 .
This mode allows multiple repeaters with a « Transmitter / Receiver» pair.
Caution : Considering the frequency jump performed, only the first 54
channels are available. If the channel is set above No. 54, a configuration
error is indicated by the Led
LD5
.
Configuration and example : Transmitter on channel No. 22, repeater Jump on channel No.
22 and receiver on channel 32.
1.
Turn on the «Transmitter / Receiver» pair.
2.
Change the radio channel of the pair onto channel No. 32 (see procedure on product
technical manuals).
3.
Turn off the receiver.
4.
Change the radio channel of the transmitter onto channel No. 22.
5.
Turn on and configure the repeater onto radio operating mode 2 and radio channel No. 22.
Enabling this mode is transcribed by a continuously flashing of the LED LD5 .
6.
Perform the «identity code learn» procedure (see Section 4.2.5).
7.
Turn on the «Transmitter / Receiver» pair, the radio message travels through the repeater
from radio channel No. 22 to radio channel No. 32.
8.
Verify proper operation by turning off the repeater Jump . The safety relays of the receiver
must be deactivated in the duration of the passive shutdown of the system.
A B
LD1
LD5
CHARGE
ERROR
CONFIG
ERROR
CONFIGURATION
TENS UNITS
LD2
LD3
LD4
1
ON
2 3 4 5 6 7 8
CONFIGURATION
Jump
(«Battery» version shown)
«ON» position = MODE 2
(trans. channel ≠ reception channel)
Position «OFF» = MODE 1
(trans. channel = reception channel)
cursor No. 5
!
!