Installation Manual
Spring Cable Reel
BEF150 – BEF500
MAL6100-0001a-EN
www.conductix.com
translated document
Page 48 of 54
BEF150
Fig. 32 BEF150 Change of rotation direction, parallel connection
→
Section 9.3 describes the steps needed for preparation.
→
Loosen the threaded pin [1] of the fastening flange, then pull off the flange [2], V-ring [3] and spacer [4].
→
On the flange side, loosen the cylinder screws [5] of the connection between the end flange and the reel body.
→
Remove the silicone joint between the end flange [6] and the reel body.
→
Carefully pull off the end flange with its bearing flange.
→
Carefully lift out the protective housings.
→
Loosen the threaded pin on the spring nut [9] still on the axis, pull out the spring nut, turn it by 180° and fasten it onto the axis.
→
Turn the towing part protective housings by 180°, insert them into the guide and insert them one after the other.
→
Insert the end flange with its bearing flange [6] onto the axis (with the spacer as stop) and use the cylinder screws [5] to fasten
it to the reel body.
→
Insert and fasten the spacer [5], V-ring [3] and flange [2].
→
Secure the threaded pin [1] against loosening.
→
Seal the cuts on the reel with silicone.
→
Connect the reel (see Chapter 7).
WARNING!
Danger of death by electrocution!
→
Earth the device on the earthing connection (PE) of the slip ring body!